Zebra ZXP 3 series

To Next Page

To Previous Page

20 ZXP Series 3 Linux Printer Driver Installation Guide P1075320-001

3: Installing the Driver

Silent Mode Installation

To install the Zebra ZXP Series 3 Driver:

• Open the Terminal.

• Change the directory to where your have downloaded Zebra ZXP Series 3 ﬁles.

For example: cd /home/zebra/Desktop

• Extract the ﬁles using the following command:

# tar -xvf <tar.gz ﬁle name>

For Example: #tar -xvf Uniﬁed_Zebra_ZXP3_Series_Card_Printer_Driver-0.0.1.3-

Linux-x86_64-Install.tar.gz

• Launch the installer in silent mode usning the following command:

#sudo ./Uniﬁed_Zebra_ZXP3_Series_Card_Printer_Driver-0.0.x.x-Linux-

x86_64-Install --mode silent

• Enter the password to continue the installation. When the messages stop, press

Enter again for the command prompt.

• Plug in the printer and turn it on.

• The printer will be added automatically by the Zebra PnP.

Zebra ZXP 3 series - Page 24