Zebra ZXP 7 series - Page 121

P1036101-001 Zebra ZXP Series 7 Card Printer User’s Manual 117
6
Cleaning
6.1 Introduction
Clean the Printer using the Cleaning Cards provided in the Printer Cleaning Kit specified in
the Note above. The regular use of these cards will clean and maintain important parts of the
printer, including the Printhead, Transport Rollers, and optional Magnetic Encoder Station.
Printer usage (total number of cards printed and total number of cards laminated) can be found
on the printer’s Properties, Device Information tab. To access the Device Information tab,
select Start > Devices and Printers. Right click on the Zebra ZXP Series 7 Card Printer
listing, and select Printer properties > Device Information.
Caution • PROTECT YOUR FACTORY WARRANTY!
The recommended cleaning procedures must be performed to maintain your
factory warranty. Allow only Zebra authorized technicians to service the Printer
for all tasks other than the recommended cleaning procedures described in
this manual.
NEVER loosen, tighten, adjust, bend, etc., any part or cable inside the printer.
NEVER use a high pressure air compressor to remove particles in the printer.
NOTE • To order a Printer Cleaning Kit, go to http://www.zebra.com/supplies.