Zebra ZXP 7 series - Driver Settings and Options

166 Zebra ZXP Series 7 Card Printer User’s Manual P1036101-001
D: Magnetic Card Encoder
Driver Settings (Printing Preferences)
To access Printing Preferences, select Start > Devices and Printers. Right click on the Zebra
ZXP Series 7 Card Printer in the listing. Select Printing Preferences.
Initial Setup
Step 1. Select the Encoding tab.
Step 2. Make your selection(s) for Magnetic encoding:
• Magnetic encoder verification: When selected, the protocol is (1) Write mag
data; (2) Verify mag data; (3) If this fails, verify again; (4) If the second verify
fails, rewrite and verify; (5) If this cycle fails, eject the card.
• Coercivity: Selections are High or Low
• Magnetic encoding type: Selections are ISO, AAMVA, CUSTOM,
and BINARY.
Step 3. Click on the Apply button, then click the OK button.