Zebra ZXP 7 series - Connecting Power and Computer

2: Installation and Setup
Loading the Laminate
P1036101-001 Zebra ZXP Series 7 Card Printer User’s Manual 29
Laminating Contact Smart Cards
Use registered laminate for the top surface of a contact smart card. This type of laminate
has a repeating pattern of an index hole and a rectangular cutout to expose the card’s
electrical contacts.
Step 1. Remove the Upper Laminate Cassette; see Page 21.
Step 2. Open the cassette, and remove the laminate if present.
Step 3. Load the smart card laminate into the cassette; see Page 23.
Step 4. Cut the laminate, splitting the index hole as shown.
electrical contacts
index hole
rectangular cutout
Cut the laminate, splitting the
index hole