Cleaning
Cleaning the Laminator
P1013372-001 Rev. A Zebra ZXP Series 8 Card Printer with Laminator 113
Step 8. For the dual-sided laminator only:
a. Locate the roller (circled below) for the lower cassette.
b. Use a second Cleaning Swab in the Laminator Cleaning Kit. Bend the swab to
release the cleaning fluid.
c. Press Bottom.
d. Clean the bottom media roller by moving swab tip side-to-side as it turns five
full revolutions. Only use moderate force.
e. When the operation is complete, press Exit.
Step 9. Reinstall the Laminate Cassette(s).
Step 10. Close the Laminator Door.
To Next Page
Loading...