Zebra ZXP 8 Series - Error Messages

54 Zebra ZXP Series 8 Card Printer with Laminator P1013372-001 Rev. A
Operation
Operator Control Panel (OCP)
Warning Messages
Warnings alert the operator to action that should be taken; the printer will generally
continue operation.
Error Messages
Errors are displayed when a situation causes the printer to stop operating. Depending on the
cause of the error message, restarting the printer or clearing the displayed error may return the
printer to operational status; or the printer may require troubleshooting and repair.
Refer to Section 7, Troubleshooting, for a list of the error messages, possible causes, and
possible solutions.
WARNING
(Printer will still operate)
DESCRIPTION
BOTTOM LAMINATE LOW Indicates that the Bottom Laminate cassette is low; see Loading
the Laminate, Section 2.
CLEAN FRONT CARD PATH Indicates that the Front Card Path (Y-Drive Rollers) needs
cleaning; see Cleaning the Printer, Section 6.
CLEAN LAMINATOR Indicates that the Laminator Path needs cleaning; see Cleaning
the Laminator, Section 6.
CLEAN LAM ROLLERS Indicates that the Laminator Media Feed Rollers need cleaning;
see Cleaning the Laminator, Section 6.
CLEAN LAM OVEN Indicates that the Laminator Transfer Path (Heated Rollers)
needs cleaning; see Cleaning the Laminator, Section 6.
CLEAN SIDE CARD PATH Indicates that the Side Card Path (X-Drive Rollers) needs
cleaning; see Cleaning the Printer, Section 6.
CLEAN TRANSFER PATH Indicates that the Transfer Path (Heated Rollers) needs
cleaning; see Cleaning the Printer, Section 6.
PRINT RIBBON LOW Indicates that the Print Ribbon spool is low; see Loading a Print
Ribbon, Section 2.
TOP LAMINATE LOW Indicates that the Top Laminate cassette is low; see Loading the
Laminate, Section 2.
TRANSFER FILM LOW Indicates that the Transfer Film spool is low; see Loading the
Transfer Film, Section 2.