76 Zebra ZXP Series 8 Card Printer with Laminator P1013372-001 Rev. A
Printer Settings and Adjustments
Card Printer Printing Preferences
Uv Panel Pop-Up
A Uv Panel is a resin-based coating similar to a “K” panel and is used to print invisible images
(text or graphics) that will glow in the visible spectrum when exposed to a Black Light.
The Uv Panel pop-up window allows you to manage and configure printing with a Uv Panel.
This window is only available when using Uv ribbons (e.g., YMCUvK) and is automatically
enabled in the driver when a recognized YMCUvK ribbon is installed.
To access the Uv Panel pop-up window, select Start > Printers and Faxes. Right click on the
Zebra ZXP Series 8 Card Printer listing, and select Printing Preferences > Card Setup.
Select Ribbon info > Front Uv... or Back Uv...
The figure below shows settings for the front side of the card; settings for the back side of the
card are identical.
• Select the Uv type:
- Disable Uv: Default, no Uv panel will be applied.
- Full Uv varnish: Prints the entire card with full Uv panel.
- Selected area blank: Using the Area Manager (described on next page) allows you to
create one or more rectangles to exclude from Uv print.
- Selected area Uv varnish: Using the Area Manager (described on next page) allows
you to create one or more rectangles to print.
- Bitmap based Uv varnish: Allows you to import a bitmap image to print on the Uv
panel; e.g., import a security seal.
To Next Page
Loading...