34 Zebra ZXP Series 3 Card Printer User’s Manual P1058486-002
3: Printer Setup
Loading Cards
Loading Cards
Card Feeder
The card feeder is used for loading cards, it can hold up to 100 cards of 30-mil thickness. The
card feeder is located under the card feeder cover of the Printer
Step 1. Set the card thickness adjustment (arrow below) to the number corresponding to the
thickness of the cards being loaded. Note that the thickness adjustment ranges from
10 mils to 40 mils.
Caution • Hold the cards by the edges only. DO NOT touch print surfaces as this can
reduce print quality.
To Next Page
Loading...
