140 Zebra ZXP Series 7 Card Printer User’s Manual P1036101-002
6: Cleaning
Cleaning the Laminator
Step 12. Press Next to conclude the laminator oven cleaning process.
Step 13. The OCP will return to the Clean Printer Menu.
Step 14. Reinstall the Heater Assembly.
a. Remove the Thumb Drive Tool (circled below).
b. While carefully sliding the Heater Assembly into place, use the Thumb Drive
Tool to slowly rotate the gears counterclockwise (dashed arrow) until the gears
mesh and the Heater Assembly seats properly.
c. Install and tighten the four thumb screws removed in Step 4.
Step 15. Close the laminator covers.
To Next Page
Loading...