Zebra ZXP Series - Magnetic Card Encoder; Introduction

P1086707-002 ZXP Series 9 Card Printer User Guide 103
Setting Custom Card Specications
Process
Step 3. The Card Specications window will appear. Enter a name in the Card type dialog
box.
Step 4. Select the encoding type for the card: Mag stripe, Contact, or Contactless.
Step 5. Make the necessary transfer temperature and speed adjustments (see “Adjustments”
on page 104) and click OK.
Step 6. Make any necessary temperature and speed adjustments to the laminator (if
equipped).
Step 7. Print and examine a Test Card (see “Printing a Test Card” on page 42). The quality
of the test card will determine whether or not to continue the process.
Step 8. If the result is satisfactory, click Save to save the current conguration. If the result is
not satisfactory, go to Step 5.
Step 9. Click Restore Defaults to start over with the default settings.