Zebra ZXP Series - Magnetic Encoding Type

P1086707-002 ZXP Series 9 Card Printer User Guide 107
Setting Custom Card Specications
Adjustments
Decrease Transfer Output Speed
Step 1. From the Card Specications window, make a note of the default transfer output
speed settings.
Step 2. Decrease the appropriate (Single or Double side) transfer output speed by 0.1.
Step 3. Click OK.
Step 4. Print a test card (see “Printing a Test Card” on page 42).
Step 5. Examine the test card.
y If there is noticeable improvement, repeat Steps 2–4 until the problem is corrected
or there is no more improvement.
y If there is no noticeable improvement, return the value to its default setting and
contact Zebra Technical Support.
Back of card
Increase Back Transfer Temperature
Step 1. From the Card Specications window, make a note of the default back transfer
temperature settings.
Step 2. Increase the appropriate (Single or Double side) back transfer temperature by 5.
Step 3. Click OK.
Step 4. Print a test card (see “Printing a Test Card” on page 42).
Step 5. Examine the test card.
y If there is noticeable improvement, repeat Steps 2–4 until the problem is corrected
or there is no more improvement.
y If there is no noticeable improvement after a number of cycles, return the value to
its default setting and go to next correction.
Decrease Transfer Input Speed
Step 1. From the Card Specications window, make a note of the default transfer input speed
settings.
Step 2. Decrease the appropriate (Single or Double) transfer input speed by 0.1.
Step 3. Click OK.
Step 4. Print a test card (see “Printing a Test Card” on page 42).