16 ZXP Series 9 Card Printer User Guide P1086707-002
Installation and Setup
Installing the Cleaning Cartridge
Installing the Cleaning Cartridge
The card cleaning cartridge (X-Cleaning Roller) cleans the cards entering the printer through the
input hopper. The cleaning cartridge consists of a cartridge frame and an adhesive roller.
Step 1. While holding the cleaning cartridge by the frame, peel the protective wrapper from
the adhesive roller. Do not touch the adhesive surface of the roller.
Step 2. Install the cleaning cartridge into the area shown in the gure below by sliding the
cartridge guide pins into the guide slots on the printer.
Step 3. Press down on the cartridge until it is fully seated.
Note • To ensure print quality, the card cleaning cartridge requires periodic replacement.
New card cleaning rollers are included with each print ribbon or may be purchased
separately. Before replacing the card cleaning cartridge or its adhesive roller, clean
the printer (see “Cleaning the Printer” on page 60). To replace the X-Roller, refer to
“Replacing the Cleaning Rollers” on page 62.
To Next Page
Loading...