P1086707-002 ZXP Series 9 Card Printer User Guide 23
Installation and Setup
Replacing the Laminate
Loading the Laminate Cassette(s)
Note • The laminate roll is specic to either the top (blue) or the bottom (yellow) laminate
cassette.
Note • The lower laminate cassette (yellow) is used on a double-sided laminator only.
Important • The geared ange on the laminate spool is removable, but do not remove it. If
it does come off, snap it back onto the end of the spool.
Step 1. Remove a new roll of laminate from its packaging and place it in the upper laminate
cassette—note the orientation of the laminate spool with respect to the laminate
cassette as shown in the gure below.
Step 2. Pull out an inch or two of laminate past the lip of the cassette.
Step 3. Close the cassette—press the two halves of the cassette together until it clicks.
Step 4. Cut the laminate square (as close to perpendicular as possible) with scissors. Hold
the scissors in one hand. Hold the cassette with the other hand. Press the laminate
rmly against the white roller thereby keeping the laminate from moving while cutting.
To Next Page
Loading...