Zebra ZXP Series - Page 76

64 ZXP Series 9 Card Printer User Guide P1086707-002
Maintenance
Cleaning the Laminator
To Clean the Media Feed Rollers:
Step 1. Select Clean Lam Med Rollers to run the laminator media roller cleaning routine.
Step 2. Lift the laminator door to its upright position.
Step 3. Remove the laminate cassette(s) (see “Removing the Laminate Cassette(s)” on
page 20).
Step 4. Leave the laminator door open
Step 5. Use the cleaning swab in the laminator cleaning kit. Bend the swab to release the
cleaning uid.
Step 6. Press Next when ready, then press Top.
Step 7. Clean the top media roller (circled below) by moving swab tip side-to-side as it turns
ve full revolutions. Only use moderate force.