Need help?Do you have a question about the Zeck Audio CA 800 and is the answer not in the manual?
General| Power (4 Ohms) | 2 x 400W |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Power Output | 800W |
| Input Sensitivity | 0.775V |
| Signal to Noise Ratio | > 100 dB |
| THD | < 0.05% |
| Input Impedance | 20 kOhms |
Explains protection against short circuits in power amps.
Explains protection against operation without speakers connected.
Explains distortion factor and its audibility in amplifiers.
Explains intermodulation distortion and its low levels in Zeck amps.
Explains signal to noise ratio and its high levels in Zeck amps.
Explains slew rate and its importance for amplifier speed.
Describes how dy loc improves bass sound quality.
Explains how dy loc manages speaker load dynamically.
To Next Page
