Getting Started Go to Contents
HFA3 Instructions for Use 2660021166131 Rev. A 2018-11
3-18
Report Output
Settings Option Description
End of Test Settings Configure settings for export to DICOM and report output settings.
DICOM Output Toggle On/Off for F
ORUM Test Database and for Export EPDF. See
Chapter (7), "Networking" for furthe
r details.
Report Output Sets the default action to be taken with automatically generated
re
ports.
Report Output Default: Use dr
op-down menu to choose output default.
Report Export File Type:
Set the default format for reports that are
exported. Note that DICOM OPV format is supported only for SFA,
Three In One, Suprathreshold, and Numeric reports.
Report Export Location: Click on the
triple dot button to set the
default destination. Browse to the location where reports have to be
ex
ported to.
Named Patient Folder:
Toggle On/Off to set whether a folder with the
patient’s name is created for a report that’s exported.
Patient ID in folder name: If Named P
atient Folder is enabled,
determine whether the patient ID is also included in the folder name by
using toggle On/Off.
Back Go back to the previous screen.
To Next Page
Loading...
