Zeiss 860 - Networking

HFA3 Instructions for Use 2660021166131 Rev. A 2018-11
Go to Contents Getting Started
3-19
Networking
Use the Networking Settings screen to configure network connections. See Chapter (7),
"Networking", for more details on network configuration.
Settings Option Description
Networking Settings Shows the network settings.
Adapter settings DHCP Enabled:
If the DHCP (Dynamic Host Configuration Protocol) is
enabled, the Host name, IP address, Subnet, Gateway, and DNS are
filled in automatically and cannot be edited.
DHCP Disabled: If
the DHCP is disabled, you can manually enter or edit
this information. Network Status is shown and MAC address is
displayed.
Network Drive
Con
figuration
Configured Network Drives: Lists available network drives and their
connection statuses. Showing the Drive Letter and Network Path.
Connected drives are indicated by a green check-mark.
Back Go back to the previous screen.