Zelmer 28Z010 - Build-In Anti-Scale System; Burst of Steam; Burst of Steam in Vertical Position

82 GW28-035_v01
Move the Steam Control Knob (Type 28Z010) –
or Dial (Type 28Z011) to selected position, in
order to set the amount of steam.
After nishing move the Temperature Dial in –
anti-clockwise direction to „MIN”; the iron is
switched off.
Move the Steam Control Knob (Type 28Z010)
or Dial (Type 28Z011) in position.
Burst of steam
– Always follow the gar-
ment manufacturer’s ironing instructions
mentioned at the garment label.
This function provides extra amount of steam to
remove stubborn wrinkles at clothes and hanging garments.
Fill the water tank with demineralised water or distilled water. See “How –
To Fill Water”.
Turn the Temperature Dial in –
clockwise direction to ●●●. Con-
nect the iron to a suitable mains
supply outlet. See „Preparation
for operation”.
Control light glows, indicating –
that the iron is on. Control light
goes off when the required tem-
perature is reached. The iron is
now ready for use.
Press the Burst of Steam Button once – steam will shoot from the holes –
of the soleplate.
For stubborn wrinkles, wait a few seconds before pressing the Burst of –
Steam Button again. Most wrinkles can be removed within three press-
es.
It may be necessary to press the burst of steam button a few times to
start this function.
For optimum steam quality, do not operate the Burst Of Steam more
than three times after the pilot light goes off.
Burst of steam in vertical position
– Always follow the garment
manufacturer’ s ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove wrinkles on delicate
garments in hanging position, hanging curtains, or other hanging fabrics.
Warning:
Do not apply steam on any clothes or fabrics that are being worn by
human or pets. Temperature of steam is very high.
Fill the water tank with demineralised water, or distilled water. See “How –
To Fill Water “.
Turn the Temperature Dial in clockwise direction to ●●●. Connect the –
iron to a suitable mains supply outlet. See „Preparation for operation”.
Control light glows, indicating that the iron is on. Control light goes off –
when the required temperature is reached. The iron is now ready for
use.
Hold the iron between 15 and 30 centimetres away from the garment. –
Press the Burst of Steam Button once – steam will shoot from the holes –
of the soleplate.
For stubborn wrinkles, wait a few seconds before pressing the Burst of –
Steam Button again. Most wrinkles can be removed within three press-
es.
It may be necessary to press the burst of steam button a few times to
start this function.
For optimum steam quality, do not operate the Burst Of Steam more
than three times after the pilot light goes off.
Build-in Anti-scale System
The build-in anti-scale cartridge is
designed to reduce the build-up of
lime scale that occurs during steam
ironing.
This will prolong the working life of
your iron. The cartridge does not
completely stop the natural process
of limes scale build-up.
Type 28Z011
Closed
steaming
„MAX”
steaming
Type 28Z010 Type 28Z011
Anti-scale
cartridge