Zendure SolarFlow ZDSPVH1200 - Page 29

9
The method of disassembly is subject to the instructions of the
microinverter, and please conrm the warranty terms of the
microinverse before disassembly.
The installation of the solar panel does not need to be moved
unless you want to change the location.
Ensure that the state after disconnection is as shown in following
gure.
Unplug the cables of the microinverter and the home grid.
Only unplug the cables of the rst solar panel and the microinverter.
The same way to unplug the cables of the second solar panel and the
micro-inverter.
Unscrew the mounting screws of the micro-inverter, remove the micro-
inverter xed on the solar panel or metal bracket.
If you have installed the balcony solar system, you need to disconnect it
according to the following steps:
Note :
Note:
Note:
5.3.3 Disconnection
1
1
2
2
3
4
3
4
EN