2
COMPATIBILITY LIST
● The installation of the ZENEC system should be carried out by an authorized installer.
Specic knowledge and tools are required to do the installation. Incorrect installation can cause
damage to the vehicle and the ZENEC system.
● Correct functioning can only be guaranteed when you use the ZENEC original accessories included
in the kit or optionally available. The ZENEC system and the original accessories must under no
circumstance be modied or altered in any way. Inappropriate actions can cause damage to the
vehicle and the ZENEC system.
● Torx screwdriver T25
● Phillips screwdriver
● Release tool made of plastic
● Hand saw or equivalent
● File
● Hex key
● Insulating tape
● The target vehicle must factory configured with preinstallation for a radio. The ZENEC system is not
compatible with vehicles that are equipped with an OE radio or OE navigation system from the
factory.
● This device installation manual applies to vehicle platforms appearing in the above compatibility list,
and in a condition as offered by the respective vehicle manufacturer. Other differing configurations
and installations of motorhome manufacturers are not considered in this installation manual. If
you have questions or vehicle-specific problems please contact the relevant motorhome
manufacturer.
● The ZENEC system is equipped with an integrated DAB+ receiver. To make use of this you will need
a suitable DAB antenna (not included in kit) that must be connected to the ZENEC system.
● If the target vehicle is equipped with a multifunction steering wheel, in order to support the steering
wheel remote functions a stalk interface accessory obtainable separately is required.
● Software updates to the ZENEC system are installed with a USB memory device.
Therefore when fitting the system make sure that the USB connection of the ZENEC system
will still be accessible later (installation of USB extension cable or USB hub).
● If you have questions or problems relating to the ZENEC system, please contact the dealer from
whom you purchased it.
Model Model Version Model Year
FIAT Ducato III 250/251 2006 – 2011
FIAT Ducato III 250/251 2011 – 2014
FIAT Ducato III 250/251 from 2014
Citroën Jumper II 250/250D/250L from 2006
Peugeot Boxer II 250/251 from 2006
TOOLS REQUIRED
No. Article Qty
1 ZENEC system 1
2 Mounting frame 1
3 Phillips screws 4
4 Remote control 2
5 microSD card with adapter 1
6 GPS antenna
1
7 Bluetooth microphone
1
THE KIT INCLUDES
8 Antenna adapter ISO/DIN
1
9 Main connection cable 1
10 USB extension cable 1
11 24-pin connection cable (4.2, Cam, MZone) 1
12 18-pin connection cable (Mic, Cam) 1
13 Connection cable parking brake 1
14 Metal plate for GPS antenna 1
15 Double-sided adhesive pad 1
CAUTION
NOTE
To Next Page
Loading...
Need help?
General
