Zenith 12 - Troubleshooting Common Issues

Troubleshooting
If this happens,..
Here is why ...
And how to correct it. . .
After loading, Frame
Counter [4] skips two or
more numbers after being
set to 'O’ position.
Film transport Lever [2] not
fully wound before counter
is set to '0' position.
Advance Transport Lever
fully before setting counter
to O'.
Frame Counter [4] 'skips',
counting incorrectly.
See above - or Counter set
before Transport Lever was
wound.
See above - always wind
Transport Lever before
setting counter.
SelMimer does not trip
shutter.
Self-Timer Lever [8J not
fully wound.Transport lever
[2] not wound.
Wind Self-Timer Lever fully
until lever points
downwards with no further
movement possible. Always
ensure Transport Lever is
fully wound before setting
Self'Timer Lever.
Rim will not rewind.
Rewind release not
engaged.
Refer back to page 17.
If anything should go wrong with your Remember that your Zenith and its
Zenith and the preceding chart has not got accessories are backed up by top-class
you out of trouble never attempt to mend it service facilities where factory-trained
yourself - you could turn a minor specialists are available to put things right,
adjustment into an expensive repair.
34