To Next Page
L
Lisa PalmerSep 18, 2025
What to do if Zenith Indoor Furnishing condenser sensor Closed?
- AAlicia SimmonsSep 18, 2025
If the condenser sensor is closed, check the ventilation. You may also need to call Zenith Service.
What to do if Zenith Indoor Furnishing condenser sensor Closed?
If the condenser sensor is closed, check the ventilation. You may also need to call Zenith Service.
How to fix boil dry protection on Zenith Water Filtration Systems?
If your Zenith Water Filtration System displays 'Boil dry protection', it means the safety feature has been activated. Turn the power off and then on again to reset the system.
What causes condenser overtemp in Zenith Water Filtration Systems?
If the condenser of your Zenith Water Filtration System is overheating, it's likely due to a blocked air filter. Remove the blockage and clean the filter. Consult the user guide for detailed instructions.
How to prevent compressor over-run in Zenith Water Filtration Systems?
If the compressor in your Zenith Water Filtration System is over-running, it might be too hot. Ensure there is adequate ventilation around the unit.
What to do if Zenith Indoor Furnishing interface fault?
If there is an interface fault, call Zenith Service.
What to do if Zenith Indoor Furnishing flood sensor Open?
If the flood sensor is open, call Zenith Service.
What to do if there is a water leak in Zenith Indoor Furnishing?
If you notice a water leak, immediately turn off the mains water supply to prevent further damage. You may also need to call for service.
How to fix Zenith Indoor Furnishing condenser screen blocked?
If the condenser screen is blocked, remove the blockage and clean the filter. Refer to the user guide for detailed instructions.
How to troubleshoot a power board fault in Zenith Water Filtration Systems?
If your Zenith Water Filtration System indicates a power board fault, check the power supply and all fuses.
What to do if Zenith Water Filtration Systems has a heater driver fault?
If your Zenith Water Filtration System is not producing hot water and shows a heater driver fault, call Zenith Service.
General| Brand | Zenith |
|---|---|
| Model | HydroTap G5 |
| Category | Kitchen & Bath Fixtures |
| Language | English |