To Next Page
J
James KleinSep 4, 2025
What to do if Zenith Water Filtration Systems displays Flood sensor Open?
- RRicardo SmithSep 4, 2025
If your Zenith Water Filtration System displays 'Flood sensor Open', call Zenith Service.
What to do if Zenith Water Filtration Systems displays Flood sensor Open?
If your Zenith Water Filtration System displays 'Flood sensor Open', call Zenith Service.
How to troubleshoot a power board fault in Zenith Water Filtration Systems?
If your Zenith Water Filtration System indicates a power board fault, check the power supply and all fuses.
Why is the hot tank under filled in my Zenith Water Filtration Systems?
If the hot tank in your Zenith Water Filtration System is under filled, it could be due to low water pressure. Check the water supply to ensure it's adequate.
What to do if Zenith Water Filtration Systems has a heater driver fault?
If your Zenith Water Filtration System is not producing hot water and shows a heater driver fault, call Zenith Service.
What to do if Zenith Water Filtration Systems displays UV Not Present?
If your Zenith Water Filtration System displays 'UV Not Present', check that the UV-C Module USB cable is correctly plugged into the HydroTap.
What to do if Zenith Water Filtration Systems displays UV Over Temp?
If your Zenith Water Filtration System displays 'UV Over Temp', verify that water is flowing through the UV-C Module when attempting to dispense.
How to fix UV Under Current error on Zenith Water Filtration Systems?
If your Zenith Water Filtration System displays 'UV Under Current', check that the power supply is correctly plugged in and turned on. Turn the system off and then on again.
How to clean condenser screen blocked in Zenith Water Filtration Systems?
If the condenser screen on your Zenith Water Filtration System is blocked, it's probably due to a blocked air filter. Remove the blockage, clean the filter, and refer to the user guide for detailed instructions.
What to do if the Zenith Water Filtration Systems compressor driver fault?
If your Zenith Water Filtration System is not dispensing chilled water and shows a compressor driver fault, call Zenith Service.
How to prevent compressor over-run in Zenith Water Filtration Systems?
If the compressor in your Zenith Water Filtration System is over-running, it might be too hot. Ensure there is adequate ventilation around the unit.
General| Brand | Zenith |
|---|---|
| Model | HydroTap G5 |
| Category | Kitchen & Bath Fixtures |
| Language | English |