Zenner multidata WR3 User Manual

8
Installation heat calculator
ZENNER recommends to mount the calculator
RQWKHZDOO'RQRWPRXQWWKHGHYLFHDWWKHSLSH
RUDWWDFKLWGLUHFWO\RQWKHÀRZVHQVRU
The mounting adapter at the backside of the cal-
culator can be used for rail mounting or “reverse”
for wall mounting.
For wall mounting attach the adapter with at least
two screws to the wall and clip the calculator on
it.
For rail mounting lift the adapter a little bit, place
the calculator on the rail and push the adapter
back until it locks.
Connection sensors
The mounting of the temperature sensors should
be done symmetrical with direct immersion. If
immersion sleeves are used they have to be
FKHFNHGIRUFRQIRUPLW\WR0,'DQGKDYHWREH
marked accordingly. The installation of immer-
VLRQVOHHYHVKDVWREHGRQHDFFRUGLQJWR',1
(1
The sensor cables are marked with colours
UHG VXSSO\EOXH UHWXUQ'RQRWEXFNOH
extend or shorten the wires!
'RRQO\XVHSDLUHGVHQVRUVZLWKWKHVDPH
serial number on it.
$WZLUHV\VWHPVWKHFDEOHOHQJWKRIWKHWHP-
perature sensor for supply and return should
QRWH[FHHGPIRU37DQGPIRU
37$WZLUHV\VWHPVWKHPD[LPXPFDEOH
OHQJWKLVP&RQVLGHU(1UHJDUGLQJ
the diameter of the wires.
Supply and return sensors must be inserted
into the immersion sleeves completely.
,QVWDOODWLRQSRLQWVLQWKHÀRZVHQVRUFDQEH
used for symmetrical installation of the tem-
perature sensors.
Seal temperature sensor after installation to
SUHYHQWXQDXWKRUL]HGGHPRXQWLQJVHDOVLQ-
FOXGHG
'RQRWZUDSRULQVWDOOZLUHVDORQJKRWSLSHV
Q
Q
Q
Q
Q
Q
Q
Rail mounting Wall mounting

Zenner multidata WR3 Specifications

General

Brand	Zenner
Model	multidata WR3
Category	Calculator
Language	English