Zenoah BC3450DW User Manual

7. Operation
■ CUTTING WORK
• Byusingthe shoulderstrap,hang theuniton your
right side. Adjust the strap length so that the cutting
head may become parallel to the ground.
(1) Shoulder strap
• Chooseasuitablerecommendedcuttingattachment
according to the object to be cut. Never use other
cutting attachment not approved by ZENOAH.
■ STOPPING ENGINE
1. Release the throttle trigger and run the engine for half
a minute.
2. Shift the stop switch to the STOP position.
(1)
(1) Stop switch
IMPORTANT
Except for an emergency, avoid stopping the engine
while pulling the throttle lever.
■ ADJUSTMENTS
Throttlecable:
The normal play is 1 or 2 mm when measured at the
carburetor side end. Readjust with the cable adjuster as
re-quired.
(1) Cable adjuster
Engineidlingspeed:
It is normal that the engine keeps running without the
blade rotation, when the throttle lever is released. When
the engine speed is too high or too slow, readjust the idle
set screw.
(1) Idle set screw
NOTE
Warm up the engine before adjusting the idling speed.
G
B
GB-11
BC3450DW / BC4350DW
BC3450DW_4350DW_GB_cs5.indd 11 17/09/05 17:04

Zenoah BC3450DW Specifications

General

Brand	Zenoah
Model	BC3450DW
Category	Brush Cutter
Language	English