OPERATION
READ THIS ENTIRE MANUAL BEFORE OPERATING YOUR E-BIKE.
Your e-bike is equipped with pedal assist, a twist throttle, and can also be used as
a regular bike. To use electric assist, the battery must be charged, inserted into the
frame, and the key must be in the battery.
1. Turned the battery key counterclockwise to the end.
2. Press power button on the left handle bar until the display lights on.
3. Ride on the bike and twist the throttle bar or pedal the e-bike to move.
Change the power level with control buttons:
‣
level 1 is the slowest,
‣
level 3 is the fastest,
‣
level 0 is human model.
Notes: The trip meter will reset when the bike is powered off. The maximum and
average speed will be calculated for a given trip, and will reset when the bike is
powered off. When the bike has not been used for 10 consecutive minutes, the
display will automatically shut down.The pedal assist and throttle features will no
longer work when the display is turned off.
YOUR FIRST RIDE
Please be VERY CAREFUL when you are ready to get on your e-bike for the first
time. The e-bike moves significantly faster than a regular bicycle at the active
power-assisted mode. Take your e-bike to an area with a lot of open space before
you start. Do not pedal hard when you get on the e-bike. You may be unprepared
for the sudden increase in speed at the first time. After a while you will get used to
it and enjoy using the pedal-assisted function.
PEDAL-ASSISTED
You must turn on the battery to use the e-bike in pedal-assisted mode.
In the pedal-assisted mode, power assist is triggered when you pedal forward,
and power assist stops when you stop pedaling, sometime would be delay. In
other words, power assist happens as long as you pedal. You don't need to pedal
hard. All you need is to apply a light force to the pedals continuously to maintain
the current flow.
To Next Page
Loading...