66
211 212
4. Now wipe the stain off again with a large clean rag.
213
Rub it out thoroughly and carefully,
leaving no fingerprints or streaks.
214
213 214
5. Now repeat for the exterior.
215
=SM81 Set the cabinet down on its back, propped up on a few
pencils, or chopsticks, or triangular strips of wood.
216
Let it dry for at least 4 hours!
215 216
6. Use a clean rag to apply a coat of MinWax Wipe-On Poly Clear Satin.
217
This is a remarkable
product that is thin enough to soak straight into the wood but thick enough to provide a decent
finish without running or dripping. Pour a little product into a disposable metal cup, like the
bottom inch cut from a soda can. Dip your rag and apply a generous coat to the whole cabinet,
starting with the interior and working around to the exterior. Be careful to “flood” those inside
corners.
218
Do NOT apply poly to the ENDS of the Port! They will get along fine without it, but if
you do poly them, the port will have a hard time fitting back in to the cabinet.
219
Set the cabinet back down on its back to dry THOROUGHLY, such as, overnight.
220
To Next Page
Loading...