13
Figure 2: Component Values and Locations
a. Start with the 22K resistors (R1, R6, R11), labeled RED, RED, ORANGE, GOLD. Compare to
its picture in the BOM. Find their locations on the circuit board and install and bend the leads
as described above
4,5
. Don’t solder any of them until all 17 resistors are installed; just bend
the leads to keep them in their place.
b. Continue with the 220K resistors (R5, R9, R10), labeled RED, RED, YELLOW, GOLD.
c. Continue with the 1.5K (or 1K5) resistors (R7, R14, R17), labeled BROWN, GREEN, RED,
GOLD. R17 has a larger lead spacing than most of the other resistors so estimate where to
bend the leads.
d. Continue with the 47K resistors (R3, R8), labeled YELLOW, VIOLET, ORANGE, GOLD.
e. Continue with the 120 ohm (or 120R) resistors (R12, R15), which are blue in color and are
labeled BROWN, RED, BLACK, BLACK, BROWN.
4 5
To Next Page
Loading...