Zepter AqueenaPro WT-100 - Display Functions; Filter Status Display

EN
15
Warning!
Pay attention to the direction of the membrane; the membrane ending with an O-ring must be placed
in the bottom part of the housing.
• Do not force the RO membrane into the membrane casing; it may cause permanent damage
to the membrane shell or membrane components.
• If the RO membrane is installed correctly in the membrane housing, there is no need to force it.
Note! If any leaks occur, all icons (“Working”, “ Water source”, “Standby” and “Flush” icons) will
fl ash at same time along with an audible alarm.
Filter Status Display: It shows the actual fi lter status.
Green light – the fi lter works at its optimum level.
Orange light - the fi lter will soon need replacing. Please contact Zepter Service for maintenance
support.
A red light along with an audible alarm (4 buzzes) means that the fi lter must be changed immediately.
Further use of the fi lter is not recommended.
5 – micron PP fi lter WT-100-72
Pellet carbon fi lter WT-100-73
1 – micron PP fi lter WT-100-74
Coconut fi lter WT-100-75
Display functions
5
3
2
1
12
53
If a display icon lights up:
Working:
Water purifi cation is in the progress, the device is in working mode.
Water
Source:
Flashing light - missing inlet water source or low inlet water pressure.
The “Water source” icon will light up with an audible alarm (7 buzzes).
Standby:
The water purifi er is in standby mode.
Flush:
The fl ushing function is activated.