Zero 88 Juggler User Manual

JUGGLER OPERATING MANUAL
If a portable or temporary three
phase mains supply is used to
power this desk, we recommend
that the desk mains plug is
removed before connecting or
disconnecting the supply.
Serious damage will occur if the
desk is connected across two
phases.
This equipment is designed for
use as a lighting control desk
only, and is unsuitable for any
other purpose. It should only be
used by, or under the
supervision of, an appropriately
qualified or trained person.
Zero 88 reserves the right to
make changes to the equipment
described in this manual without
prior notice.
E & OE.
Federal Communications Commission
This equipment has been tested and
found to comply with the limits for a
Class A digital device, pursuant to
part 15 of the FCC rules. These limits
are designed to provide reasonable
protection against harmful
interference when the equipment is
operated in a commercial
environment. This equipment
generates, uses, and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instruction manual, may cause
harmful interference to radio
communications. Operation of this
equipment in a residential area is
likely to cause unacceptable
interference in which case the user
will be required to correct the
interference at the operators expense.
Issue 1 – November 2005
Manual Stock No 73-404-00
Software Version 1.0
© Zero 88 2005
Zero 88
Usk House
Llantarnam Park
Cwmbran
Gwent NP44 3HD
United Kingdom
Tel: +44 (0)1633 838088 *
Fax: +44 (0)1633 867880
e-mail: sales@zero88.com
Web: www.zero88.com
* 24 hour answerphone

Zero 88 Juggler Specifications

General

Type	Lighting Desk
Control Protocol	DMX512
Memory	12 memories
DMX Output	XLR 5-Pin
Power Supply	90-240V AC, 50/60Hz

Summary

Preset Operation

Two Preset Operation

Outputting Scenes

Manual Fades

Explains how to perform manual crossfades using A/B Master faders and FADE TIME control.

Timed Crossfades

Explains how to perform timed crossfades using A/B Master faders and FADE TIME control.

Wide Mode Operation

Explains how to crossfade or combine two scenes for 24-channel operation in Wide Mode.

Storing and Outputting Scenes

Details the process of storing scenes temporarily and crossfading between them in Wide Mode.

Manual and Timed Fades

Sequences

Programming Sequences

Step-by-step guide to entering Program Mode and programming sequence steps using faders and buttons.

Editing Sequences

Instructions on how to edit, clear, or re-program individual steps within a sequence.

Playing Back Sequences

Explains methods to play back programmed sequences, including selecting them and stopping playback.

Manual Playback

Details how to manually step through a sequence and control fade/snap transitions.

Automatic Playback

Explains how to set playback speed and control fade/snap transitions for automatic sequence playback.

Technical Specification

External Power Supply

DMX Output