Juggler 73-404-00 Issue 1 Page 5
Manual Fades
Ensure the FADE TIME control is set to Manual. Set up a scene using the PRESET A
faders. Set up a different scene on the PRESET B faders.
Set the A MASTER to full, and the B MASTER to zero. The scene set on the PRESET A
faders is output.
To crossfade to the scene set up on PRESET B, simultaneously move the A MASTER to
zero and the B MASTER to full. You have direct control over the speed of the scene
change. As the two master faders are moved in tandem the scene set up on PRESET B
will fade in and the scene set on PRESET A will fade out.
A new scene can then be set up on PRESET A without affecting the outputs.
To crossfade to the new scene on PRESET A, simultaneously move the A MASTER to full
and the B MASTER to zero.
As the two master faders are moved in tandem the scene set up on PRESET B will fade
out and the scene set on PRESET A will fade in.
Timed Crossfades
Set the A MASTER and B MASTER faders to zero. Set up a scene using the PRESET A
faders. Set up a different scene on the PRESET B faders.
Set the FADE TIME control to the required crossfade time.
Quickly move the A MASTER fader to full. The scene on the PRESET A faders will fade in
and be output live. The time taken for the fade to complete is determined by the value set
on the FADE TIME control.
To crossfade to the scene on PRESET B, quickly move the A MASTER fader to zero and
the B MASTER fader to full. The scene on PRESET B will fade in and the scene on
PRESET A will fade out in the selected time. While the crossfade is in progress the LEDs
in the PRESET CONTROL button flash. They go out when the fade is complete.
A new scene can then be set up on PRESET A without affecting the outputs.
To crossfade to the scene on PRESET A, quickly move the A MASTER to full and the B
MASTER to zero. The scene on PRESET A will fade in and the scene on PRESET B will
fade out in the selected time.
Flashing Channels
Ensure that the flash function is active (LED in FLASH button is on).
Press and hold down an individual CHANNEL FLASH button. The channel is then added
to the scene at the level set on the GRAND MASTER.
Release the CHANNEL FLASH button. The channel returns to its previous level.
To Next Page
Loading...
Need help?
General
