Page 4 Juggler 73-404-00 Issue 1
Preset Operation
Introduction
The Juggler desk can be operated as either two 12 channel presets controlling 12
channels, or a single wide preset controlling 24 channels.
In Two Preset operation, separate scenes are set up on PRESET A and PRESET B
faders. The A MASTER and B MASTER faders are used to crossfade between the two
different scenes.
In Wide Mode, the first scene is set up on the PRESET A and PRESET B faders and is
stored temporarily using the PRESET CONTROL button. Once stored, another scene can
be set up on the PRESET A and PRESET B faders. The A MASTER and B MASTER
faders are then used to crossfade between the stored scene and the scene on the
PRESET faders.
In Two Preset and Wide Modes crossfades between scenes can be manual or timed.
Overall output is under the control of the GRAND MASTER fader.
Two Preset Operation
The PRESET A and PRESET B faders, the A MASTER and B MASTER faders and the
GRAND MASTER fader are used to control the output levels from the desk. The FADE
TIME control is used to determine the crossfade time between scenes.
Outputting Scenes
To Output a Scene from Preset A - Set the required levels for each channel on the
PRESET A faders. Set the A MASTER to full and the B MASTER to zero. The scene set
up on PRESET A is output live.
To Output a Scene from Preset B - Set the required levels for each channel on the
PRESET B faders. Set the A MASTER to zero and the B MASTER to full. The scene set
up on PRESET B is output live.
To Next Page
Loading...
Need help?
General
