Gas Pressure Regulator
This appliance requires an operating pressure of 2.8 kPa at the appliance. A suitable LPG
regulator that complies with the requirements of SANS 1237 must be installed / used.
Important Information to the User
This appliance may ONLY be installed by a certified LP gas installer. All registered installers are
issued with a card showing their registration number. Ask to be shown the card before allowing
any installation to commence and make note of the installer QCC number.
Upon completion of the installation, the installer is required to explain the operation details of
the appliance together with the safety instructions. You will be asked to sign acceptance of the
installation and be provided with a completion certificate.
You should only sign for acceptance of the installation when the installation is completed to
your satisfaction. Note that your invoice is required in the event that you wish to make a
guarantee claim.
Important Information to the Installer
This appliance may only be installed by an LP gas installer, registered to the Liquefied Petroleum
Gas Association of Southern Africa. The appliance must be installed in accordance with the
requirements of SANS 10087-1 and any fire department regulation and / or local bylaws
applicable to the area.
If in doubt, check with the relevant authority before undertaking the installation. Upon
completion of the installation, you are required to fully explain and demonstrate to the user the
operational details and safety practices applicable to the appliance and installation.
To Next Page
Loading...