4.11 TO ACTIVATE DIRECTIONAL LOCK
1. After powering up the Scout and pairing with the controller (see
section ‘Flying your Scout’) ensure that you and the Scout are
facing the same direction.
2. Press the Directional Lock Button on the top left of the Remote and
the lights on the Scout will flash indicating that the drone is now
in Directional Lock mode. It is important that you do not change
the orientation position you are standing in when you activate
Directional Lock as this will affect the control of the drone.
3. You will now be able to fly the Scout in Directional Lock mode.
4. To exit Directional Lock mode, push the Directional Lock again and
the Scout lights will shine solid again.
5. MAINTENANCE
5.1 CLEANING:
Avoid exposing your Scout and its accessories to dust, sand and
moisture as these can damage the Scout. If the Scout is exposed to dust
or sand, use a soft brush to remove any visible particles.
ROTOR BLADE REPLACEMENT:
1. Use the included screwdriver to remove the screw on the top of the
Rotor Blade.
2. Gently remove the Rotor Blade.
3. Ensure that you are replacing the Rotor Blade with the correct blade as
there are two different orientations of blades which are labeled A
and B on the underside of the blade.
IF THE INCORRECT BLADE IS USED IN THE INCORRECT PLACEMENT
THE SCOUT WILL NOT WORK.
Different colour Rotor Blades are used front and back on your Scout
so it is easy to identify the front and rear of the Scout when flying. To
ensure that it is easy to fly the Scout make sure that the front and rear
blades are different colours.
4. Gently push the replacement Rotor Blade into place. Replace the
screw being careful not to over tighten. If the screw will not fit in
place, remove the screw and make sure that the holes on both the
Rotor Blade and the rod are aligned.
To Next Page
Loading...
Need help?
General
