DC EVSE Standalone DC Fast Charger 31
3.2.2 Exterior Inspection
Inspect the exterior housing. The housing is made of welded metal with a
painted surface. Slight rust will not aect the performance of the charger.
However, if the charger develops major rust during or after the warranty
period, contact the Owner/Operator for instructions.
Inspect the charging connector, charging cable, and the connector holder.
There should not be bends or twists in the charging cable. The metal contacts
of the connector should not fade or be rusty. If there is damage, contact the
Owner/Operator.
If the cabinet or screen is broken, cracked, open, or shows other signs of
damage, contact the Owner/Operator.
3.2.3 Interior Inspection
Tighten the main power junctions every month. A loose connection can result
in damage to the charger or electrical re. Make sure the screw is torqued
properly. See Appendix C - Torque Requirements Table in the installation
manual.
Test the cables for continuity.
Look for evidence of water intrusion and damage. If there is evidence of water
intrusion or damage, contact the Owner/Operator.
3.2.4 Cleaning
Keep the exterior clean at all times. Clean the cabinet exterior with a damp
cloth or wet cotton towel. Use light pressure and tap water or cleaning agents
with a PH level between 6 to 8.
Do not apply high-pressure water jets.
Do not use abrasive cleaning agents or tools. Abrasive cleaning agents can
damage the coating, paint, nish, and durability of the exterior parts.
Clean the cabinet interior at least three times a year.
3.2.5 Cooling
The charger is cooled by forced air. Keep the charger in a ventilated location
and do not block the air vents.
Clean the air lters regularly.
Replace the air lters every 6 to 12 months.
The following limited warranty covers all Zerova EV Chargers sold to
authorized Zerova Reseller Partners.
To Next Page