Section 4. Programming
4-10
49# ___# Mobile-to-Mobile Paging
(0 = Disabled, 1 = Enabled)
0
Autodial Numbers
Programming for the Autodial numbers is done in three parts. First the command
is entered, and the patch responds with a double-beep to prompt for the next
entry. Next the Autodial slot that is being programmed is entered (0 to 49), and
the prompt is repeated. Finally, the phone number itself is entered, and the patch
responds with a five-beep prompt. Autodial numbers can be up to 16 digits long.
A one second pause can be inserted in the dialing sequence by entering a “*”.
50# _# ____# Program Autodial Numbers (0 to 49)
Dial Tone Disconnect
This command is used to automatically terminate a call after the phone party
hangs up. If enabled, this command sets the number of seconds of continuous
vox that will be detected as dial tone. Once this threshold is exceeded, the call is
disconnected. This parameter only applies once a call enters the conversation
mode; the initial dial tone at the start of a call or after a hook-flash is performed
are not affected by this time limit.
53# _# Dial Tone Detect Time (1 to 9, 0 = disabled) 0
Non-DTMF Mobile Access
When this command is enabled, non-DTMF equipped radios can access the
Model 30 to place a phone call simply by keying up four times in rapid
succession. If four separate carrier detects occur, less than a second apart, the
patch will go off hook and dial the number programmed in Autodial slot #1. The
phone party can disconnect the call by sending “#0” from a DTMF phone.
DTMF equipped mobile users continue to access the patch in the normal way.
57# ___# Non-DTMF Mobile Access
(0 = Disabled, 1 = Enabled)
0
Dual Function Connect Button
In normal operation, when the Connect button is pressed, the Model 30 connects
the phone to the radio and drops directly into the conversation mode. When this
command is enabled, what the patch does depends on whether or not the channel
is busy. If there is no carrier present, the patch rings on the air to signal a mobile
user. If there is carrier activity, the patch drops into the conversation mode. As
always, pressing the button after a call is in progress disconnects the call.
To Next Page
Loading...