ZETRON 30 Worldpatch - Page 5

Table of Contents
(Continued)
COR Hold Time ........................................................... 4-12
Busy Tone Detector..................................................... 4-12
PL Strip Output............................................................ 4-12
Auxiliary Output Control .............................................. 4-12
Program Access Code ................................................ 4-13
Reset All Parameters to Factory Default..................... 4-13
Installation Tests ......................................................... 4-13
Exit Program Mode...................................................... 4-13
TWO-TONE TABLES ....................................................... 4-14
Two-Tone Timing ........................................................ 4-14
Two-Tone Tone Groups .............................................. 4-14
Two-Tone Code Plans................................................. 4-16
5. INSTALLATION
INSTALLATION WARNING.............................................. 5-1
GENERAL......................................................................... 5-1
EQUIPMENT REQUIRED FOR INSTALLATION............. 5-1
INSTALLATION PROCEDURE........................................ 5-1
TEST AND ADJUSTMENTS / INITIAL TURN-ON ........... 5-2
OPTIONAL DIGITAL VOICE DELAY ............................... 5-5
INSTALLING THE SELCALL OPTION............................. 5-6
6. REPAIR
IN CASE OF DIFFICULTY ............................................... 6-1
TROUBLESHOOTING ..................................................... 6-1
COR and Squelch Problems ....................................... 6-1
Unreliable Dialing or Misdialed Numbers.................... 6-1
Unable to Access Dial Tone or Answer a Call ............ 6-2
Intermittently Disconnecting During a Call .................. 6-2
MODEL 30 CONTROL BOARD (702-9321K) .................. 6-3
Parts List...................................................................... 6-3
Schematic.................................................................... 6-5
Silkscreen.................................................................... 6-8
7. PROGRAMMING LOG AND QUICK REFERENCE
PROGRAMMING.............................................................. 7-1
Programming Example................................................ 7-1
PROGRAMMING LOG AND QUICK REFERENCE ........ 7-2
AUTODIAL PROGRAMMING LOG.................................. 7-6