INTRODUCTION
8
EN 3201.758.001a 2016-02
1.1.2 CONVERSION TABLE
1.2 CONVENTIONS FOR SAFETY INFORMATION IN TEXT
The following conventions apply for the safety information in these Operating Instructions:
• Ensure you read and understand all warnings prior to commissioning or repairing the product!
• Pass on all safety information to personnel involved in operating, maintenance, repair and transport!
S.I. INTERNATIONAL SYSTEM OTHERS
1 [mm] = 0.03937 [in]
10 [mm] = 0.3937 [in]
25.4 [mm] = 1 [in]
6.4516 [cm
2
]= 1 [sq. in]
1[m
2
] = 1550 [sq. in]
16.387 [cm
3
]= 1 [cu. in]
0.473 [dm
3
]= 1 [U.S. pint]
1 [l] = 61.02 [cu. in]
1 [l] = 0.2642 [U.S. gal]
1.772 [g] = 1 [oz]
0.4536 [kg] = 1 [lb]
0.00070308 [kg/mm
2
]= 1 [lb/sq. in]
1 [bar] = 14.51 [psi]
1 [kg·m] = 7.246 [lb·ft]
30.48 [cm] = 1 [feet]
Describes a dangerous situation that can lead to serious injuries or death when not avoided.
Describes a dangerous situation that can lead to serious injuries or death when not avoided.
Describes a dangerous situation that can lead to minor o moderate injuries when not avoided.
Describe a situation which can lead material damage when not avoided.
NOTE:
Serves to draw attention to special procedures, methods, information, use of aids and tools, etc. This document specially
highlights safety information according to US standard ANSI Z535 by marking the text with the above signal words according
to the degree of danger.
To Next Page
Loading...
