Shenzhen Zhurui Technology Co.,Ltd.
10 / 13
Timer setting ( common timer(timers 3-9)setting)
Switch settings
Alarm settings
1. See the “Process of entering into setting pages”, enter the alarm setting page.
2. Press “
” key to set the alarm, now the hundreds place of Voltage is white
words on blue background.
3. Use “
” key, “ ” key, and “ ” key to set the alarm value of
voltage, now the cursor jump to the “Enabled” checkbox of voltage.
4. Press “
” key to set voltage alarm or not, then press “ ” key to the
current alarm setting.
5. Repeat step 3 and step 4 until all items are set, now the cursor jump to the
“OK” button.
6. Press “
” key to save the settings and quit. Press “ ” key to quit
without any changes.
1. See the “Process of entering into setting pages”, select “timer3” to “timer9”
submenu item and enter the general timer setting page.
2. Press “
” key to set the timer, now the “Enabled” checkbox is blue.
3. Press “
” key to check or uncheck this checkbox, then press “ ” key ,
“
” key and “ ” key to set the start time and outlet state of the timer;
4. Next set the time and outlet state of the Second groups.
5. Set the outlet state is whether repeated everyday or not, if needed to do the
action of the group timer everyday, please check “Everyday” checkbox, if not
needed, please don’t check this checkbox. If the “Everyday” checkbox is not
checked, then it will turn off this timer after the second group timer
performed.
6. At last press “
” key to move the cursor to the “OK” button, press
“
” key to save the settings and quit. Press “ ” key to quit without
any changes.
1. See the “Process of entering into setting pages”, enter the outlet setting page.
2. Press “
” key or “ ” key to move the cursor to item needed, “On”
means it automatically power on the outlet and begin to supply electricity to
the electrical equipment after the machine start up; “Off” means it power off
the outlet after the machine start up, unless press “
” more than 3
seconds to power on the outlet , “Same as last time” means the machine will
remember the last outlet states, and will set the outlet state same as last time
after the machine start up.
3. Press “
” key to move the cursor to the “OK” button, press “ ” key to
save the settings and quit. Press “
” key to quit without any changes.
To Next Page
Loading...
Need help?
General