ZiLOG System 8000 User Manual

USER
24
Zilog
USER
RETURN, either alone or after the new contents.
This displays the next register. A "Q" followed by
a
RETURN terminates the command.
Exam~le
Display all registers.
<R (CR)
RO Rl R2 R3
R4 R5
R6
0000 0000 0000 0000 0000 0000
0000
R6 R7 R8 R9
RIO
Rll
R12
0000
0000
0000 0000
0000 0000 0000
R13 R14 R15 RPC RFC
0000
0000 0000 0000 0000
Exam~le
Display 32-bit word register RR4 and alter its contents.
<R RR4 (CR)
RR4 00000000 <A257FFFF (CR)
RR6 00000000 <Q (CR»
BREAK
Syntax
BREAK <address> [<n>]
Descri~tion
The BREAK command sets a breakpoint at a given even address
after clearing any previously set breakpoint. If <n> is
given, program execution is not interrupted until the nth
time the breakpoint instruction is encountered «n> is in
the range %l-%FFFF). If <n> is not given, 1 is assumed. If
the BREAK command is issued with no parameters, any previ-
ously set breakpoint is cleared. When program execution is
suspended by the BREAK command, the Monitor Program displays
a message reporting the break and the address where it
occurred.
Exam~le
Message: BREAK AT 6A5E
Zilog
24

ZiLOG System 8000 Specifications

General

Brand	ZiLOG
Model	System 8000
Category	Desktop
Language	English