Zimmer Biomet Tricera User Manual (English)

Other manuals for Zimmer Biomet Tricera

Questions and Answers:

C
christine30Aug 4, 2025
How to replace a fuse in Zimmer Biomet Tricera Medical Equipment controller?
- K
  karen86Aug 4, 2025
  To replace a blown fuse in the Zimmer Biomet Medical Equipment controller: * Turn off the power and disconnect the power cord from the electrical outlet. * Open the Power Entry Module’s Fuse Drawer on the back of the Controller. * Remove and replace both fuses with 5x20mm 6.3A/250VAC Type “T” (slow blow) fuses. * Close the fuse drawer. Note: Only use the specified type of fuses. There are no other user-serviceable parts; return the cleaned unit to the manufacturer for other replacements.
R
robertsautumnAug 9, 2025
What to do if Zimmer Biomet Medical Equipment handpiece will not run?
- A
  Adriana WilsonAug 9, 2025
  If the Zimmer Biomet Medical Equipment handpiece isn't running, it could be due to a couple of reasons. First, check that the handpiece is properly connected to the controller; if not, remove and reconnect the handpiece cable to the controller according to the RELIGN Tricera System instructions. Alternatively, the cord might be malfunctioning, in which case you should send the handpiece to RELIGN for repair.
B
Brian HawkinsAug 14, 2025
What to do if the shaver blade/RF probe is not correctly detected by the Zimmer Biomet Tricera Medical Equipment handpiece?
- A
  angelathorntonAug 14, 2025
  If the shaver blade/RF probe isn't being correctly detected by the Zimmer Biomet Medical Equipment handpiece, there are a couple of things you can try. First, remove the shaver blade/RF probe and reinsert it according to the RELIGN Tricera System instructions. If that doesn't work, the handpiece may be malfunctioning. Remove and reconnect the shaver blade/RF probe to another Tricera Handpiece to confirm the possible cause. Send the malfunctioning Tricera Handpiece to RELIGN for repair.
S
Samantha HallAug 18, 2025
Why is the Activate function not operating smoothly on my Zimmer Biomet Tricera Medical Equipment?
- J
  jacksonbrandiAug 19, 2025
  If the Activate function is not operating smoothly on your Zimmer Biomet Medical Equipment, it could be due to a malfunctioning cable or controller. To troubleshoot, remove and reconnect the handpiece to a different Controller. If the problem persists, send the Tricera Handpiece to RELIGN for repair.
T
tannerdeanAug 25, 2025
How to fix a shaver blade that does not turn in Zimmer Biomet Tricera Medical Equipment?
- D
  donna63Aug 25, 2025
  If the shaver blade in your Zimmer Biomet Medical Equipment isn't turning, it might not be inserted properly. Remove the blade and reinsert it according to the RELIGN Tricera System instructions for directions on use of the Tricera Handpiece as part of the RELIGN Tricera System.
N
Nicole WrightAug 28, 2025
How to remove staining and discoloration from Zimmer Biomet Tricera Medical Equipment?
- M
  Mackenzie DavisAug 29, 2025
  Staining and discoloration on Zimmer Biomet Medical Equipment can occur due to inadequate cleaning, such as remaining protein residues, or if cleaning solutions are contaminated or being reused. To resolve this, clean in accordance with section 10.1, and always use freshly prepared solutions. Repeat cleaning in accordance with section 10.1.