Figure 7. Reinsert the battery screw and tab to the scooter with the
battery box inserted. Make sure that the locking tab is pushing down
both sides of the battery box. Insert the screw in tightly to securely lock
the battery box into place.
Figure 8. Engage the battery of the scooter by pushing the
freewheel lever backwards. This will engage the drive motor.
( WARNING! Make sure that the scooter is on level ground
prior to engaging the drive motor. The scooters wheels are
engaged). Insert the key to make sure that the battery box is
installed properly. The scooter should beep once prior to
indicating the battery level. If not repeat steps 5-7.
Figure 9. Insert the chrome seat post extension into the seat post. Insert
the seat post pin in at the desired height. Secure the seat post by
securely inserting the seat post screw locking the seat post to the
scooter.
Figure 10. Install the seat by lowering the seat into the seat post
extension, pushing down it until it locks into position. You may have to
wiggle the seat slightly until it is facing towards the tiller. Insert the
armrests one on each side into the armrest slots. Secure the armrests
with the armrest locking screws.
NOTE: To use the swivel seat function push the lever (located at the right
of the seat).
To Next Page
Loading...
Need help?
General
