Zip HYDROTAP G4 series - Page 9

0908
USER MANUAL
805846UK - ZIP HYDROTAP G4 V1.00 NOV 2017
TECHNICAL SUPPORT TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
SECTION CLASSIC HYDROTAP
CS models, press to dispense
Chilled water
Sparkling water
BCS, BC, BA, B models, touch to dispense
Boiling water
+
Activate / deactivate the safety lock see page 27
Either
4. 3 CLASSIC HYDROTAP - OPERATION
4. 4 CLASSIC HYDROTAP - SAFETY LOCK
4. 5 CLASSIC HYDROTAP - SAFETY SENSOR
Pull both levers forward
Safety
sensor
• Shield the HydroTap G4 from any
direct sunlight.
• With the Command Centre in
normal operating mode and safety
lock enabled, turn the power off.
• Pull both tap levers to the forward
position.
• Turn the power on.
• The Command Centre will calibrate
the safety sensor.
• Return the levers to the neutral
position.
Safety sensor calibration
Calibrate the safety sensor at installation.
Shield all direct sunlight from the HydroTap G4, during the calibration.