To Next Page
T
toddgriffinJul 28, 2025
What to do if I see a water leak in my Zip HydroTap BCS?
- Sstephanie10Jul 28, 2025
If you notice a water leak in your Zip Water System, immediately turn off the mains water supply. Then, call for service.
What to do if I see a water leak in my Zip HydroTap BCS?
If you notice a water leak in your Zip Water System, immediately turn off the mains water supply. Then, call for service.
How to troubleshoot a power board fault in my Zip Water System?
If there's a power board fault in your Zip Water System, check the power supply and all fuses.
What to do if the condenser screen is blocked on my Zip HydroTap BCS?
If the condenser screen is blocked on your Zip Water System, it's likely due to a blocked air filter. Remove the blockage, clean the filter, and check the user guide for further instructions.
Why is the compressor over-running on my Zip HydroTap BCS?
If the compressor is over-running on your Zip Water System, it might be too hot. Check the ventilation to ensure it's adequate.
What causes a condenser overtemp in Zip HydroTap BCS Water System?
If your Zip Water System is experiencing a condenser overtemp, it's likely due to a blocked air filter. Remove the blockage, clean the filter, and consult the user guide.
Why is the hot tank under filled in my Zip HydroTap BCS Water System?
If the hot tank in your Zip Water System is underfilled, it could be due to low water pressure. Check the water supply to ensure it's sufficient.
How to reset boil dry protection on a Zip HydroTap BCS Water System?
If the boil dry protection has been activated on your Zip Water System, the safety mechanism has been triggered. Turn the power OFF and then ON to reset it.
Checklist of items and conditions required before installation.
Critical safety guidelines for installation and operation.
Compliance information and general warnings.
List and description of included parts and optional accessories.
Prerequisites and site preparation guidelines before installation.
Essential safety advice for storing CO2 gas cylinders.
Instructions for safely mounting the CO2 cylinder.
Steps to attach the regulator to the CO2 cylinder.
Procedure for linking the gas hose from regulator to unit.
Method to detect gas leaks at connections using soapy water.
Detailed steps for conducting a gas leak test after connections.
Guidance on connecting the appropriate electrical power cable.
Procedures for fitting water hoses and using tube connectors.
Steps to purge CO2 gas from the system.
Procedure for flushing the newly installed filter cartridge.
Procedure to calibrate the boiling water temperature.
Explanation of integral and required backflow prevention systems.
General| Filtered Water | Yes |
|---|---|
| Safety Lock | Yes |
| Power Supply | 220-240V, 50Hz |
| Boiling Water Temperature | 98°C |
| Chilled Water Temperature | 5-10°C |
| Sparkling Water Capacity | Not applicable |
| Warranty | 2 years |
| Finish Options | Brushed Chrome, Matte Black |
| Product Type | Boiling, Chilled & Filtered Water System |
| Water Pressure | 250kPa - 700kPa |
| Filtration | 0.2 micron filter |
| Dimensions | Varies by model |
| Temperature Control | Adjustable |
