To Next PageTo Next PageWhat to do if there is a water leak in my Zip Water System?
If you notice a water leak in your Zip Water System, the first thing you should do is turn off the mains water supply. Then, call for service.
What to do if the condenser screen is blocked in my Zip Water System?
If the condenser screen is blocked in your Zip Water System, it's likely due to a blocked air filter. Remove the blockage, clean the filter, and check the user guide for detailed instructions.
What to do if the hot tank is under filled in my Zip Water System?
If the hot tank in your Zip Water System is under filled, this may be due to low water pressure. Check the water supply to ensure adequate pressure.
Why is my Zip Water System condenser overheating?
If your Zip Water System is experiencing condenser overtemp, the cause may be a blocked air filter. Remove any blockage, clean the filter, and consult the user guide.
How to reset boil dry protection in Zip Water System?
If the boil dry protection has been activated on your Zip Water System, reset the system by turning the power OFF and then ON again.
What to do if there is a water leak in my Zip Water Dispenser?
If you notice a water leak, immediately turn off the mains water supply. After that call for service.
How to fix a blocked condenser screen on a Zip Water Dispenser?
If the condenser screen is blocked, remove the blockage, clean the filter, and check the user guide.
What causes condenser overtemp in Zip Water Dispenser and how to resolve it?
Condenser overtemperature is often caused by a blocked air filter. To resolve this, remove the blockage, clean the filter, and consult the user guide.
What to do if my Zip Water Dispenser shows a hot overload?
If your Zip Water Dispenser indicates a hot overload, turn the unit OFF to reset it and call Zip Service.
What does a level board fault mean on my Zip Water Dispenser?
A level board fault usually indicates an internal fault, so call Zip Service.
General| Power Supply | 220-240V, 50Hz |
|---|---|
| Series | G4 |
| Water Pressure | 250kPa - 700kPa |
| Temperature Control | Adjustable temperature settings |
| Finish Options | Chrome, Brushed Chrome, Matte Black |
| Filtration | 0.2 micron filtration |
| Controls | Touch |
| Material | stainless steel |
| Warranty | 5 year comprehensive warranty (appliance warranty 36 months plus additional 24 months tank warranty) |
