802742UK - G4 IS IT industrial installation instructions - Jan. 2016 - V2.03 Page 11 of 32
Section 1
Tap installation
1.1 Generic requirements
Special tools required
In addition to normal tools, the following will be required.
For the industrial HydroTap
®
G4.
•
35mm diameter sheet metal hole punch for sinks (not supplied).
•
35mm diameter hole saw for worktops (not supplied).
•
Nut runner tube spanner (supplied) for fixing the tap assembly.
When installing a font, the following will be required
•
108mm diameter sheet metal punch or hole saw to suit surface being cut.
Hole positioning
Position the tap such that it dispenses into the sink bowl with ample clearance for a cup or tea pot.
Alternatively, the tap could be mounted away from the sink using a Zip Font, available as an accessory
(see Major components and accessories, page 8).
Tap positioning
Tap Recommended dispensing
distance (mm)
Top touch tap 74
Side touch tap 94
Industrial side touch
two button HydroTap
®
G4
94
Note All images are for illustrative purposes, to aid understanding
of the system configuration, and are not prescriptive of tap
positioning.
• Ensure that the taps are mounted to minimise the risk of scalding.
• Ensure that the taps are mounted in a position that allows the
water to safely drain to waste.
To Next Page
Loading...
