Zip HYDROTAP G4 series - Filter Life and Usage Adjustment

Page 24 of 32 802742UK - G4 IS IT industrial installation instructions - Jan 2016 - V2.03
Installation instructions
4.3 USB connection
Connect the cable from the tap to the black junction box, using the round 4 pin plug. Orient the USB plug
carefully and connect it to the Command-Centre
TM
, do not force the plug. Once connected, fix the cable and
junction box to the wall, ensure they are away from any possible water splashes and are off the floor.
Black junction box
4.4 Connecting the water suply
To prevent sediment from entering the HydroTap
®
at connection. First, open the access door and check that
the filter is in place and secure, then flush water through the supply line thoroughly, before connection to the
HydroTap
®
. Connect the water supply to the Command-Centre
TM
using the attached braided flexible hose.
Tap cable
USB
connector
4 pin plug