Zip HYDROTAP G4 series - Celsius HydroTap; Celsius Controls, Lights, and Operation

802742UK - G4 IS IT industrial installation instructions - Jan. 2016 - V2.03 Page 13 of 32
Section 2
Ventilation
Important See section 4 Command-Centre
TM
installation,
pages 23 to 25.
Vent cut-out details
A Air outlet vent
B Air inlet vent
A
B
C
C Ducted vent
When installing air flow vents, the following tools will be required
• Jigsaw and drill.
• Keyhole or wall board saw.
Preferred ventilation arrangement shown below.
The ducted vent kit supplied with the Command-Centre
TM
exhausting through the kick-space should be used,
to provide adequate ventilation in all conditions. (Ancillary components are not shown in these diagrams).
100mm
min.
Position vent grille on
either the kick board or the
cupboard ends
Inlet grille should be
fitted in baseboard
Cupboard back must be
fully closed to prevent
recirculation into
cupboard from
kick space.
A