Page 28 of 32 802742UK - G4 IS IT industrial installation instructions - Jan 2016 - V2.03
5.6 Legacy mode
Note Legacy mode must be enabled for all industrial side touch and top touch taps to function with the
Command-Centre
TM
.
•
Press [Menu] button for main menu.
•
Press [Service].
•
Enter the current password.
(Please contact your local service centre for details).
•
Select [Resets/ Install].
•
Select [Legacy Tap].
•
In the next screen select [Enable].
Note Once the unit has been set to operate in legacy
mode it will stay in legacy mode, even if the power is
turned off and on.
Legacy mode will be disabled if the unit is re-set to the
factory default settings. In this instance, it will be
necessary to re-enable the legacy mode settings as
shown above.
Commissioning
To Next Page
Loading...
