Zip HYDROTAP G4 series - Date, Time, and Temperature Settings

802742UK - G4 IS IT industrial installation instructions - Jan. 2016 - V2.03 Page 23 of 32
If an external filter is installed, select position B
B
Rotate 90°
only
1
2
3
4
Check the table below to determine which filter bypass position you need for your product.
4.2 Braided hose fitting
Install the mains water braided hoses to the Command-Centre
TM
before locating in place.
Section 4
Command-Centre
TM
installation
Ifnoexternallterisinstalled,selectpositionA
A
Rotate 90°
only
1
2
3
4
4.1 External bypass valve
The diverter bypass valve allows the user to choose to have the boiling feed water bypass the internal filter
and only be filtered by the external filtration. This diverter valve is located at the rear panel of the
Command-Centre
TM
, see the diagram below.
Leave in position A until after commissioning (section 5). Select position B if scale filter is fitted, before
flushing the scale filter as described on page 22.